Yes, you can use the electric heat strip for with an Advent AC unit:
**Electric Heat Strip for Advent Air RV Air Conditioners - 5,500 BTU # ACMHD.
*Advent Air RV Air Conditioner - 13,500 Btu - White # ACM135.
These two units are made for each other. view full answer...
On your 2015 Winnebago Brave I recommend starting with the Roadmaster Rear Anti-Sway Bar part # RM-1139-145 this will help a great deal by adding an additional heavier sway bar to combat the side to side movement that is incredibly common when driving a motorhome. There is a notable difference in the ride after installation.
The second thing I always recommend is the Roadmaster Reflex Steering Stabilizer with Mounting Brackets for Class A Motor Homes part # RM-RBK22-RSSA this will eliminate... view full answer...
It sounds like the Buyers Products Rocker Switch # 3373014187 will work very well for a replacement switch in your 1995 Southwind RV. this is a 3 pin momentary open/close switch that features overall dimensions of 2" tall/long, 1" wide, and about 2" deep (I have attached a diagram to assist).
It has a continuous current rating of 10 amps and is made right here in the USA. view full answer...
The most common upgrades we see on motorhomes is rear anti-sway bar, sumo springs front/rear, and steering stabilizer in that order. These are the most worthwhile upgrades and the ones you will notice an improvement from most. I have attached the correct options below.
Roadmaster Rear Anti-Sway Bar part # RM-1139-146
SumoSprings Rebel Custom Helper Springs part # SSF-170-40-2 (Front) and part # SSR-184-40-1 (Rear)
Roadmaster Reflex Steering Stabilizer part # RM-RBK22-RSSA view full answer...
The best option we have for you is to use the Valterra Check Valve part # P23415LFVP and then go to a local hardware store to look for a 1/2" to 5/8" adapter as we do not carry a check valve with both 1/2" MPT and 5/8" MPT fittings. These are pretty common through so I don't think you will have any issue finding one. In order to join the fittings together you will also want to use the Valterra PTFE Thread Seal Tape part # A05-0265. view full answer...
Your model number of 7333C886 means you have a Coleman Mach and the correct replacement shroud is the MaxxAir part # MA00-325001 which you referenced. view full answer...
I do have an option for you but there aren't any brake controller wiring provisions on the Workhorse chassis. That said, all you will have to do is run some wires from the trailer connector to the the controller and then from the controller to the battery using the Wiring Kit for 2, 4, 6, and 8 Brake Electric Trailer Brake Controllers part # 5506. This will be almost everything you need to install an electric trailer brake controller like the Tekonsha Prodigy P3 Trailer Brake Controller... view full answer...
Go To Results